Aluminum casing also facilitates passive cooling.Ĭonnect:Amp, power cord, Ethernet cable, and Quickstart Guide. (89 x 185 x 207 mm)Īnodized precision machined extrusion aluminum case.
You can plug a Sonos product directly into your router if your WiFi is unstable.ģ.50 x 7.28 x 8.15 in. You must use Ethernet cables to connect both Sonos products to your router when you use Connect:Amp for surround sound.Ĭonnects to your home WiFi network with any 802.11b/g/n router.Ĩ02.11n only network configurations are not supported-you can either change the router settings to 802.11b/g/n or connect a Sonos product to your router. Pairs with a Sonos home theater speaker for a true surround sound experience. Spring binding posts (in North America, the Connect:Amp has combined spring binding post/banana jack connectors).
#SONOS CONNECT AMP TILBUD INSTALL#
Repeat to install the other speaker wires.ġ10W RMS (2x55W continuous average power into 8 ohms, THD+N<0.02%)* Mismatching of polarities will result in weak central sound, and a distorted sense of sound direction. Note: Connect the red (+) and black (-) terminals from each speaker to the corresponding terminals on the Connect:Amp. The stripped portion should be caught firmly in the connector post. Insert the stripped end of the speaker wire into the hole, and then release. Use your thumb or finger to firmly push the spring-loaded speaker connector post inward to reveal the connection hole. Don’t connect speakers rated at less than 4 ohms. Your speaker’s power rating should be at least 55W for 8 ohm speakers, and at least 100W for 4 ohm speakers. The system will detect when a cable is connected to the subwoofer output and adjust the crossover frequency automatically. You may connect a powered subwoofer to this output using a standard RCA cable. Note: If you disconnect your subwoofer, make sure to also disconnect the subwoofer’s cable from the Connect:Amp output. You may use a standard RCA audio cable to connect the Connect:Amp’s analog audio inputs to the audio outputs from a separate audio component, like a turntable.
Use only the supplied power cord to connect to a power outlet (using a third party power cord will void your warranty). Select the appropriate voltage setting for your country. Use high-quality speaker wire to connect the left speaker to Connect:Amp. Use high-quality speaker wire to connect the right speaker to Connect:Amp. You can use an Ethernet cable (supplied) to connect to a router, computer, or additional network device like a network-attached storage (NAS) device.
0 kommentar(er)
